A pad sized to exactly what it has to bear, carrying a rebar grid for the weight on top and a base worked for the shrink-swell clay below, so it holds its place without lifting or sinking, whether it sits behind a new McKinney home or an established one off the square.
Credibility comes from how it's built, not from promises. Here's the order of operations on every concrete pads & slabs job.
We moisture-condition, compact, and grade the base over Blackland clay so the weight rides evenly and the pad neither lifts nor drops as the soil pulls in water and then surrenders it back below.
The thickness follows whatever ends up sitting on the pad. A garden-shed footprint and a shop floor under rolling gear are not remotely the same pour.
Our standard reinforcement here is a tied rebar grid, sized to carry the load and span the movement our expansive ground hands every slab; on the lightest pads we may drop to mesh, but the heavy work gets the rebar.
Under an enclosed or finished pad we roll out a vapor barrier so dampness in the ground stays put below rather than wicking up into the slab.
We set a well-proportioned mix, saw the control joints, and run a cure schedule so the afternoon heat can't pull the early strength back out of the surface.
Most contractors vanish after the deposit. We pick up the phone, show up when we say, and stand behind the work after the truck leaves. The follow-through is the difference.
A foreman we know runs your job and a vetted crew does the work, managed by Billy's, one company accountable from the first call to the final walkthrough.
COI and lien waivers on file before we break ground. The documentation that lets commercial clients pay and gives homeowners peace of mind.
Prepped subgrade, reinforced and mixed to spec for the job, and proper curing. We build credibility through the process, not promises. On concrete pads & slabs, that starts with work the clay base.
A pad here gets priced off the load on top and the soil beneath: a rebar grid matched to the use, a compacted base over expansive clay, and a cure held against the summer sun. As a starting range, most pads and slabs begin near $7 to $13 per square foot, moving with thickness and whether a vapor barrier is part of the build. We size and quote each one against the weight it has to carry.
The weight decides. A shed pad needs far less than a garage floor or a shop slab parked under trucks and gear, so we tie the thickness and the rebar to your actual use and to the expansive clay underneath every bit of it.
Yes. Both are heavy and drive their weight down through a handful of points, so we deepen the pour and tie in a heavier rebar grid. A hot tub in particular needs a flat, dependable base that won't tip or sink as the clay works, which puts the groundwork on equal footing with the slab. Give us the equipment list and we shape the pad around it.
For an enclosed or finished slab, usually so; the barrier blocks ground moisture from working its way up through the concrete. We weigh that call pad by pad against the job the slab is going to do.
Some do, hinging on the size, the location, and the use, and McKinney's rules can run differently from a neighboring Collin County town's. We raise it when a permit looks likely so it gets handled ahead of the pour instead of after the fact.
Concrete carries on gaining strength long past the point the top looks finished. We give you a firm date to set equipment on your particular pour, with that week's heat figured into it.
You'll hear back from a real person, usually the same day. No call center, no runaround, no chasing us down.
Booking up fast this season. Or call (469) 557-4581